1996 Jaguar XJSFACTORY OEM SERVICE PROCEDURE

Battery Terminal Under Load Test

To check battery terminal voltage under load, connect voltmeter across battery terminals and operate starter. See Fig 1 . If voltmeter reads about 10 volts, go to next test. A voltage reading of less than 10 volts indicates excessive current flow in circuit. Remove starter for bench testing. See BENCH TESTINGΒ  .

Fig 1: Testing Battery Terminal Voltage Under Load
G92C00531Courtesy of JAGUAR CARS, INC.
Chapter Navigation
Factory Service Tools

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • β€’ You smell fuel, burning insulation, or see smoke.
  • β€’ Brakes feel soft, pull hard to one side, or make grinding noises.
  • β€’ The engine overheats, stalls repeatedly, or misfires under load.
  • β€’ You are missing required tools, torque specs, or safe lifting equipment.
  • β€’ You are not confident in the next step or safety outcome.