1982 Jaguar XJ6 BaseFACTORY OEM SERVICE PROCEDURE

LUCAS Alternators: Description

NOTE: Some Jaguar models may be equipped with Motorola alternators. See appropriate article in this section.

Lucas ACR model alternators have an integral, non-adjustable voltage regulator, mounted in the slip ring end bracket. Individual connectors are used to connect external wiring to the alternator.

The rotor, which turns inside the stator, has its field windings connected to 2 face-type slip rings. It is supported in the drive-end bracket by ball bearings and in the end cover by needle roller bearings.

One positive and 1 negative carbon brush ride against concentric brass slip rings. The heat sink, rectifier, and terminal block assembly incorporates 6 silicon diodes, forming a full-wave rectifier bridge circuit, and 3 diodes which supply current to the rotor windings.

Individual diodes cannot be removed from the heat sink assemblies. A surge protection diode, in the outer face of the slip ring end bracket, protects the diode pack from high transient voltages resulting from faulty cable connections.

NOTE: Precautions should be taken while attaching and detaching cables, as surge protection is limited. Observe polarity and never connect or disconnect wires while engine is running.
APPLICATION

Model Type No.
XJ6
Β  With Air Conditioning 25 ACR
Β  Without Air Conditioning 18 ACR
XJS 25 ACR
Fig 1: Exploded View of Lucas 25 ACR Alternator with Integral Regulator
G09330209Courtesy of NOT AVAILABLE
SPECIFICATIONS

Β  Nominal Output
Alternator Amps@6000 RPM Voltage
18 ACR 45 14
25 ACR 66 14
Factory Service Tools

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • β€’ You smell fuel, burning insulation, or see smoke.
  • β€’ Brakes feel soft, pull hard to one side, or make grinding noises.
  • β€’ The engine overheats, stalls repeatedly, or misfires under load.
  • β€’ You are missing required tools, torque specs, or safe lifting equipment.
  • β€’ You are not confident in the next step or safety outcome.