Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
2004 Isuzu Axiom Base, RWDFACTORY OEM SERVICE PROCEDURE
Winter Drive Mode
- The winter switch will operate when switched on after all of the following conditions are present:
- The gear select position is "P", "R", "N" and "D" range only.
- Vehicle speed is 7 mph (11 km/h) or less.
- Transmission oil temperature is 120°C (248°F) or less.
- Accelerator opening is 8% or less.
- Cancel Release
- Cancellation by driver
- Turning off the winter drive mode switch
- Shifting select position to "3", "2", or "L" (Winter drive mode is not canceled by selecting "N", "R", or "P")
- Ignition key is turned off.
- Automatic cancellation
- When vehicle runs at 22 mph (35 km/h) or more for 1 second or more
- Cancellation by driver
- When transmission oil temperature reaches 140°C (284°F) or above
NOTE:
The mode returns to normal drive mode after the winter drive mode is canceled.
Factory Service Tools
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.