Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
2004 Isuzu Axiom Base, RWDFACTORY OEM SERVICE PROCEDURE
Neutral Start Switch (Mode Switch): Installation
To install, follow the removal steps in the reverse order, noting the following points;
If a engine starts at any selector position except "N" or "P", the neutral start switch (mode switch) should be adjusted.
- Loosen the neutral start switch bolt and set the shift selector to the "N" range.
- Align the groove and neutral basic line.
- Hold in position and tighten the bolt and nut.
Torque:
- Nut - 7 N.m (61 lb in)
- Bolt - 13 N.m (113 lb in)
- Lock the nut with the lock washer tubs at two points.
Factory Service Tools
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.