Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
2004 Isuzu Axiom Base, RWDFACTORY OEM SERVICE PROCEDURE
Major Components (2): Reassembly
- Install the converter housing.
Torque:Β
- M10Β - 34 N.m (25 lb ft)
- M12Β - 57 N.m (42 lb ft)
- Install the snap ring, key and rotor (4x2).
- Install the snap ring to the output shaft.
- Install the key and rotor.
- Install the spacer, ball, speedometer sensor drive gear and snap ring (4x2).
- Install the spacer, ball and speedometer sensor drive gear.
- Install the snap ring to the output shaft.
- Install the key, rotor and snap ring (4x4).
- Install the key and rotor.
- Install the snap ring to the output shaft.
- Install the second brake drum gasket.
- Install a new second brake drum gasket to the transmission case.
- Individual piston operation inspection.
Check for the sound of operation while injecting compressed air into the oil hole indicated in Fig 5 .
Factory Service Tools
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- β’ You smell fuel, burning insulation, or see smoke.
- β’ Brakes feel soft, pull hard to one side, or make grinding noises.
- β’ The engine overheats, stalls repeatedly, or misfires under load.
- β’ You are missing required tools, torque specs, or safe lifting equipment.
- β’ You are not confident in the next step or safety outcome.
