2004 Isuzu Axiom Base, 4WDFACTORY OEM SERVICE PROCEDURE

Immobilizer System DTCS

IMMOBILIZER SYSTEM DIAGNOSTIC TROUBLE CODES (DTC) LIST

DTC Description
B8001 Replace Electronic Control Unit (ECU) (Immobilizer Fault)
B8002 Immobilizer Not Programmed
B8003 Immobilizer Control Unit Is Not Programmed.
B8004 Immobilizer Coil Circuit (Antenna Coil Fault)
B8005 Communication Line W Voltage Low
B8006 Communication Line W Voltage High
B8007 No Engine Request Received Wrong Transponder Key
B8008 Wrong Transponder Key
B8009 No Transponder Key Programmed
B8010 Unknown Transponder Key
Factory Service Tools

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • β€’ You smell fuel, burning insulation, or see smoke.
  • β€’ Brakes feel soft, pull hard to one side, or make grinding noises.
  • β€’ The engine overheats, stalls repeatedly, or misfires under load.
  • β€’ You are missing required tools, torque specs, or safe lifting equipment.
  • β€’ You are not confident in the next step or safety outcome.