2004 Isuzu Ascender S, RWDFACTORY OEM SERVICE PROCEDURE

Wheel Alignment Specifications

Wheel Alignment Specifications

Camber Cross Camber Cross Caster Left Caster Right Caster Steering Wheel Angle Thrust Angle Toe (Total)
-0.5°
+/-0.5°
0.0°
+/-0.3°
-0.5°
+/-0.5°
3.5°
+/-0.5°
4.0°
+/-0.5°
-0.5°
+/-3.5°
0.0°
+/-0.4°
0.1°
+/-0.2°
Factory Service Tools

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • • You smell fuel, burning insulation, or see smoke.
  • • Brakes feel soft, pull hard to one side, or make grinding noises.
  • • The engine overheats, stalls repeatedly, or misfires under load.
  • • You are missing required tools, torque specs, or safe lifting equipment.
  • • You are not confident in the next step or safety outcome.