Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
2004 Isuzu Ascender S, RWDFACTORY OEM SERVICE PROCEDURE
Body Control Module DTCS
BODY CONTROL MODULE DIAGNOSTIC TROUBLE CODE (DTC) LIST
| DTC | DEFINITION |
|---|---|
| DTC B1000 | Module Has Detected An Internal Malfunction |
| DTC B1004 | KAM In Module Has Been Reset |
| DTC B1007 | Module Data Mismatch |
| DTC B1009 | Module Data Value Not Zero |
| DTC B1397 | Short To Ground In 12-Volt Reference Circuit |
| DTC B1440 | Monitored Ignition Switch Circuit Has Malfunctioned |
| DTC C0550 | Control Module Detects An Internal Malfunction |
Factory Service Tools
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- β’ You smell fuel, burning insulation, or see smoke.
- β’ Brakes feel soft, pull hard to one side, or make grinding noises.
- β’ The engine overheats, stalls repeatedly, or misfires under load.
- β’ You are missing required tools, torque specs, or safe lifting equipment.
- β’ You are not confident in the next step or safety outcome.
