Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
2004 Isuzu Ascender S, RWDFACTORY OEM SERVICE PROCEDURE
Inspection/Maintenance (I/M) System DTC Table
Inspection/Maintenance (I/M) System DTC Table
| System | DTCs Required to Set System Status to YES |
|---|---|
| AIR | DTC P0410 |
| Catalyst | DTC P0420 |
| Evaporative Emission (EVAP) | DTC P0442 DTC P0446 DTC P0496 |
| Oxygen Sensor | DTC P0130 DTC P0131 DTC P0132 DTC P0133 DTC P0134 DTC P0137 DTC P0138 DTC P0140 DTC P1133 DTC P1137 DTC P1138 |
| Oxygen Sensor Heater | DTC P0135 or P0141 |
Factory Service Tools
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- β’ You smell fuel, burning insulation, or see smoke.
- β’ Brakes feel soft, pull hard to one side, or make grinding noises.
- β’ The engine overheats, stalls repeatedly, or misfires under load.
- β’ You are missing required tools, torque specs, or safe lifting equipment.
- β’ You are not confident in the next step or safety outcome.
