2004 Isuzu Ascender S, RWDFACTORY OEM SERVICE PROCEDURE

Hard Start

Hard Start

Inspections Action
DEFINITION: The engine cranks normally, but does not start in a normal amount of time. The engine does eventually run, or may start but immediately dies.
Preliminary
  • Refer to Important Preliminary Check Before Starting in Symptoms - Engine Controls  .
  • Search for bulletins.
  • Make sure the vehicle operator is using the correct starting procedure.
Sensor/System Monitor the engine coolant temperature (ECT) sensor with the scan tool. Compare the engine coolant temperature with the ambient air temperature on a cold engine. If the coolant temperature reading is more than 5 degrees more or less than the ambient air temperature on a cold engine, check for high resistance in the coolant sensor circuit.
Fuel System
Ignition System
  • Inspect the spark plugs for the following conditions:
  • Inspect for loose ignition coil connections.
  • Inspect for loose ignition control module connections.
  • Inspect for a faulty control module or ignition system grounds.
Engine Mechanical
Additional Inspect for a restricted exhaust. Refer to Restricted Exhaust in Engine Exhaust.
Factory Service Tools

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • • You smell fuel, burning insulation, or see smoke.
  • • Brakes feel soft, pull hard to one side, or make grinding noises.
  • • The engine overheats, stalls repeatedly, or misfires under load.
  • • You are missing required tools, torque specs, or safe lifting equipment.
  • • You are not confident in the next step or safety outcome.