2004 Isuzu Ascender S, RWDFACTORY OEM SERVICE PROCEDURE

Removal Procedure

  1. Relieve the fuel system pressure. Refer to the Fuel Pressure Relief ProcedureΒ .
  2. Raise the vehicle. Refer to Lifting and Jacking the Vehicle in General Information.
  3. Remove the frame brace. Refer to Frame Brace Replacement (Short Wheelbase) or Frame Brace Replacement (Long Wheelbase) in Frame and Underbody.
  4. Remove the fuel tank shield, if equipped. Refer to Fuel Tank Shield Replacement (Short Wheelbase) or Fuel Tank Shield Replacement (Long Wheelbase) in Frame and Underbody.
  5. Drain the fuel tank. Refer to Fuel Tank Draining ProcedureΒ .
  6. Fig 1: View Of Fuel Tank & Related Components
    GM887435Courtesy of GENERAL MOTORS CORP.
  7. Disconnect the fuel tank pressure sensor electrical connector (3).
  8. Disconnect the evaporative emission (EVAP) vent valve electrical connector (2).
  9. Fig 2: Locating Fuel Return Pipe, Fuel Feed Pipe & EVAP Purge Pipe
    GM893021Courtesy of GENERAL MOTORS CORP.
  10. Disconnect the fuel return pipe, the fuel feed pipe and the EVAP purge pipe (1). Refer to Quick Connect Fitting(s) Service (Plastic Collar)Β .
  11. Cap the fuel and EVAP pipes in order to prevent possible fuel system contamination.
  12. With the aid of an assistant, support the fuel tank.
  13. Fig 3: Locating Fuel Tank Components
    GM887432Courtesy of GENERAL MOTORS CORP.
Factory Service Tools

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • β€’ You smell fuel, burning insulation, or see smoke.
  • β€’ Brakes feel soft, pull hard to one side, or make grinding noises.
  • β€’ The engine overheats, stalls repeatedly, or misfires under load.
  • β€’ You are missing required tools, torque specs, or safe lifting equipment.
  • β€’ You are not confident in the next step or safety outcome.