2004 Isuzu Ascender 2WD L6-4.2LFACTORY OEM SERVICE PROCEDURE

Connector Views

Powertrain Control Module (PCM) - C1:

Factory service manual diagram



PCM C1 (Pin 1-13):

Factory service manual diagram



PCM C1 (Pin 14-58):

Factory service manual diagram



PCM C1 (Pin 59-65):

Factory service manual diagram





Powertrain Control Module (PCM) - C2:

Factory service manual diagram



PCM C2 (Pin 1-11):

Factory service manual diagram



PCM C2 (Pin 12-37):

Factory service manual diagram



PCM C2 (Pin 38-65):

Factory service manual diagram





Powertrain Control Module (PCM) - C3:

Factory service manual diagram



PCM C3 (with Connector Part Information):

Factory service manual diagram



PCM C3 (Pin 1-48):

Factory service manual diagram



PCM C3 (Pin 49-65):

Factory service manual diagram



Chapter Navigation
Factory Service Tools

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • β€’ You smell fuel, burning insulation, or see smoke.
  • β€’ Brakes feel soft, pull hard to one side, or make grinding noises.
  • β€’ The engine overheats, stalls repeatedly, or misfires under load.
  • β€’ You are missing required tools, torque specs, or safe lifting equipment.
  • β€’ You are not confident in the next step or safety outcome.