Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
2003 Isuzu Rodeo LS, 2.2 DFACTORY OEM SERVICE PROCEDURE
Testing Procedure
- Perform DIAGNOSTIC SYSTEM CHECK - ENGINE CONTROLS in SELF-DIAGNOSTICS - 4.2L ASCENDER article. When the check is complete, go to next step.
- Turn ignition on, with engine off. Command the fuel pump relay ON with a scan tool. If the fuel pump operates, go to next step. If the fuel pump does not operate, see FUEL PUMP ELECTRICAL CIRCUIT DIAGNOSIS .
NOTE:
Inspect the fuel system for damage or external leaks before proceeding with this diagnostic.
NOTE:
Verify that adequate fuel is in the fuel tank before proceeding with this diagnostic.
Factory Service Tools
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.