2003 Isuzu Rodeo 2WD L4-2.2LFACTORY OEM SERVICE PROCEDURE

Cruise Control Main Switch

Removal
1. Disconnect the battery ground cable.

Factory service manual diagram



2. Remove the meter cluster assembly (1).
- Refer to the Instrument Panel Assembly in Body Structure section.

3. Remove the cruise control main switch (3).
- Disconnect the switch connector.
- To remove the cruise main switch, illumination controller and transfer switch assembly (2), push the lock from the back side of the meter cluster assembly.
- Remove the cruise main switch from the back side of the switch assembly (2).

Installation
To install, follow the removal steps in the reverse order.
Factory Service Tools

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • β€’ You smell fuel, burning insulation, or see smoke.
  • β€’ Brakes feel soft, pull hard to one side, or make grinding noises.
  • β€’ The engine overheats, stalls repeatedly, or misfires under load.
  • β€’ You are missing required tools, torque specs, or safe lifting equipment.
  • β€’ You are not confident in the next step or safety outcome.

Rather have a pro handle this?

A certified mobile mechanic comes to your home or office. They bring the tools, you stay comfortable. No tow truck, no waiting room, no surprises.

Comes to youSame-day available12-month warranty
Get a Free Quote

No obligation. See pricing before you book.