2003 Isuzu Axiom Base, RWDFACTORY OEM SERVICE PROCEDURE

Transmission Assembly: Installation

  1. Slowly raise transmission jack until front of the transmission assembly is aligned with rear of the engine. Attach the transmission assembly to the engine.
  2. Tighten engine transmission bolts as shown in the figure.
    Fig 1: Transmission Bolts Torque Specifications
    G02808390Courtesy of ISUZU MOTOR CO.
  3. Align the flex plate torque converter bolt boss with flex plate hole by turning the torque converter. Install flex plate torque converter bolts (6 pieces) by turning the crankshaft.

    Torque:Β  54 N.m (40 lb ft)

    NOTE: Do not reuse the flex plate torque converter bolt.
Factory Service Tools

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • β€’ You smell fuel, burning insulation, or see smoke.
  • β€’ Brakes feel soft, pull hard to one side, or make grinding noises.
  • β€’ The engine overheats, stalls repeatedly, or misfires under load.
  • β€’ You are missing required tools, torque specs, or safe lifting equipment.
  • β€’ You are not confident in the next step or safety outcome.