Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
2003 Isuzu Axiom Base, RWDFACTORY OEM SERVICE PROCEDURE
Select Cable: Removal
- Pull the hand parking brake.
- Set selector lever in "R" position.
- Remove knee pads, cluster upper cover, center cluster assembly, rear console, front console, selector lever knob and cover assembly.
- Refer to SELECTOR LEVERΒ .
- Disconnect inner cable by pulling projection on pin.
- Press down claws and disconnect cable assembly.
- Remove nuts that fasten grommet in select cable assembly.
- Disconnect inner cable.
- Slide sleeve and disconnect cable assembly.
- Pull lock.
- Draw select cable assembly into the interior side.
Factory Service Tools
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- β’ You smell fuel, burning insulation, or see smoke.
- β’ Brakes feel soft, pull hard to one side, or make grinding noises.
- β’ The engine overheats, stalls repeatedly, or misfires under load.
- β’ You are missing required tools, torque specs, or safe lifting equipment.
- β’ You are not confident in the next step or safety outcome.
