2003 Isuzu Axiom Base, RWDFACTORY OEM SERVICE PROCEDURE

Hold In Test

Observe that the pinion stays when the lead wire is disconnected from terminal "C". See Fig 1.

Fig 1: Checking Pinion When Wire Is Disconnected From Terminal "C "
G00211935Courtesy of ISUZU MOTOR CO.
Chapter Navigation
Factory Service Tools

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • β€’ You smell fuel, burning insulation, or see smoke.
  • β€’ Brakes feel soft, pull hard to one side, or make grinding noises.
  • β€’ The engine overheats, stalls repeatedly, or misfires under load.
  • β€’ You are missing required tools, torque specs, or safe lifting equipment.
  • β€’ You are not confident in the next step or safety outcome.