Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
2003 Isuzu Axiom Base, RWDFACTORY OEM SERVICE PROCEDURE
Generators & Regulators: Overhaul: Generator: Reassembly
To reassemble, follow the disassembly steps in the reverse order of removal.
NOTE:
- Never make battery connections with polarities reversed, or battery will be shorted via the diodes. This will cause damage to the diodes.
- Do not connect generator B terminal to the ground, it is directly connected to the battery. This cable will burn if it is connected to the ground.
- Ensure to disconnect the positive (+) terminal of the battery when quick-charging battery. Diodes may be damaged due to the abnormal pulse voltage generated by the quick charger.
- When reassembling the front section to rear section, insert a stiff wire into hole in the rear face of the rear cover from the outboard side to support the brush in raised position. Insert the front section to which rotor is assembled.
- Reassemble parts carefully to be sure they fit into their original position, paying attention to the insulated portions.
- Wipe insulating tubes, washers and plates clean and install them in position carefully to avoid getting oil or grease on them.
- Using a press with a socket wrench attached, reassemble rotor and rear end cover assembly in the front cover. See Fig 1 .
- Install pulley on the rotor. Secure the pulley directly in the vise between two copper plates, and tighten nut to specifications. See TORQUE SPECIFICATIONSΒ . See Fig 2 .
Factory Service Tools
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- β’ You smell fuel, burning insulation, or see smoke.
- β’ Brakes feel soft, pull hard to one side, or make grinding noises.
- β’ The engine overheats, stalls repeatedly, or misfires under load.
- β’ You are missing required tools, torque specs, or safe lifting equipment.
- β’ You are not confident in the next step or safety outcome.
