2003 Isuzu Axiom Base, RWDFACTORY OEM SERVICE PROCEDURE

Inflator Module: Removal

  1. Turn the steering wheel so that the vehicle's wheels are pointing straight ahead.
  2. Turn the ignition switch to "LOCK".
  3. Disconnect the battery "-" terminal cable, and wait at least 5 minutes.
  4. Disconnect the yellow 2-way SRS connector located under the steering column.
  5. Loosen the inflator module fixing bolt from behind the steering wheel assembly using a TORX® driver or equivalent until the inflator module can be released from steering assembly.
    Fig 1: Loosening Inflator Module Fixing Bolt
    G02714381Courtesy of ISUZU MOTOR CO.
  6. Disconnect the yellow 2-way SRS connector and horn lead located behind the inflator module.
    Fig 2: Disconnecting Yellow 2-Way SRS Connector And Horn Lead
    G02714382Courtesy of ISUZU MOTOR CO.
  7. Remove inflator module.
Factory Service Tools

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • • You smell fuel, burning insulation, or see smoke.
  • • Brakes feel soft, pull hard to one side, or make grinding noises.
  • • The engine overheats, stalls repeatedly, or misfires under load.
  • • You are missing required tools, torque specs, or safe lifting equipment.
  • • You are not confident in the next step or safety outcome.