2003 Isuzu Axiom Base, RWDFACTORY OEM SERVICE PROCEDURE

Programming PCM

  1. Select "Body" and "immobilize".
  2. Select "Programming" and "Program Immobilizer Function".
  3. Input a program option, by moving the cursor on the selection, then press "Enter" key.
    Fig 1: Identifying Programming PCM Mode Display (1 Of 2)
    G02715469Courtesy of ISUZU MOTOR CO.
  4. Enter the security code.
  5. Input the security code, then press the soft key of "Okay" or "Not Okay".
    Fig 2: Identifying Programming PCM Mode Display (2 Of 2)
    G02715470Courtesy of ISUZU MOTOR CO.
  6. Turn on the Ignition.
  7. Select an Engine system.
  8. See the display of programming result.
Factory Service Tools

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • β€’ You smell fuel, burning insulation, or see smoke.
  • β€’ Brakes feel soft, pull hard to one side, or make grinding noises.
  • β€’ The engine overheats, stalls repeatedly, or misfires under load.
  • β€’ You are missing required tools, torque specs, or safe lifting equipment.
  • β€’ You are not confident in the next step or safety outcome.