2003 Isuzu Axiom 2WD V6-3.5LFACTORY OEM SERVICE PROCEDURE

Alignment

Caster Front 2°30' ± 45'
Camber Rear 0° ± 1°
Camber Front 0° ± 30'
Toe-in (Front) 0 ± 2 mm (0 ± 0.08 inch)
Toe-in (Rear) 0 ± 5 mm (0 ± 0.2 inch)
Toe-Axis (Rear) ± 1°
Factory Service Tools

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • β€’ You smell fuel, burning insulation, or see smoke.
  • β€’ Brakes feel soft, pull hard to one side, or make grinding noises.
  • β€’ The engine overheats, stalls repeatedly, or misfires under load.
  • β€’ You are missing required tools, torque specs, or safe lifting equipment.
  • β€’ You are not confident in the next step or safety outcome.