2003 Isuzu Axiom 2WD V6-3.5LFACTORY OEM SERVICE PROCEDURE

Powertrain Control Module

Circuit Operation
The powertrain control module (PCM) receives inputs from switches and sensors, and controls the functions of transmission mode. The multi-plexed indicator control unit also controls the "POWER DRIVE", "WINTER DRIVE", "All OIL TEMP", and "CHECK TRANS" indicator lights and allows for diagnostic testing through the Data Link Connector, (DLC).
Factory Service Tools

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • β€’ You smell fuel, burning insulation, or see smoke.
  • β€’ Brakes feel soft, pull hard to one side, or make grinding noises.
  • β€’ The engine overheats, stalls repeatedly, or misfires under load.
  • β€’ You are missing required tools, torque specs, or safe lifting equipment.
  • β€’ You are not confident in the next step or safety outcome.