2002 Isuzu Trooper LS, RWDFACTORY OEM SERVICE PROCEDURE

Steering Column: Installation

  1. Install steering column assembly.
  2. Align the setting marks on the universal joint and steering shaft made during removal.
  3. Tighten the steering column fixing bolt (dash panel) to the specified torque.

    Torque:  19 N.m (14 lb ft)

  4. Tighten the steering column fixing bolt (pedal bracket) to the specified torque.

    Torque:  17 N.m (13 lb ft)

  5. Tighten the universal joint to the specified torque.

    Torque:  25 N.m (18 lb ft)

  6. Install lock cylinder assembly.
  7. Install shift lock cable (For A/T).
  8. Install cushion rubber.
  9. Install snap ring.
  10. Install Combination switch and SRS coil assembly. After installation of combination switch assembly, connect the combination switch wiring harness connector and the SRS 2-way connector located under the steering column.
  11. Turn the SRS coil counterclockwise to full, return about 3 turns and align the neutral mark.
    CAUTION: When turning the SRS coil counterclockwise to full, stop turning if resistance is felt. Forced further turning may damage to the cable in the SRS coil.
Factory Service Tools

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.

Shop Manual-Ready ToolsCompare Repair QuoteQuote Shield Pro

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • • You smell fuel, burning insulation, or see smoke.
  • • Brakes feel soft, pull hard to one side, or make grinding noises.
  • • The engine overheats, stalls repeatedly, or misfires under load.
  • • You are missing required tools, torque specs, or safe lifting equipment.
  • • You are not confident in the next step or safety outcome.