Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
2002 Isuzu Trooper LS, RWDFACTORY OEM SERVICE PROCEDURE
Inflator Module: Installation
- Install inflator module.CAUTION:
- Never use the air bag assembly from another vehicle. Use only the air bag assembly for "UX".
- Support the module and carefully connect the module connector.NOTE: Pass the lead wire through the tabs on the plastic cover (wire protector) of inflator to prevent lead wire from being pinched.
- Secure the module with one bolt to relieve weight on the wire connector and tighten bolts to specified sequence as illustrated.
Torque: 8 N.m (69 lb in)
- Connect the yellow 2-way SRS connector located under the steering column.
- Connect the battery "-" (negative) terminal cable.
- Set ignition to "ON" while watching warning light. Light should flash 7 times and then go off. If lamp does not operate correctly, refer to AIR BAG RESTRAINT SYSTEMS .
Factory Service Tools
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.