Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
Circuit Description
PCM monitors unexpected PCM reset. This will not illuminate MIL. PCM will record DTC P1636.
When DTC sets, PCM will not illuminate MIL. PCM will store conditions present when DTC was set as FAILURE RECORDS data only.
PCM will turn MIL off on third consecutive trip cycle during which diagnostic runs and fault is no longer recognized. A history DTC will clear after 40 consecutive trip cycles during which diagnostic runs and fault is no longer recognized. DTC can be cleared with scan tool, or by disconnecting battery voltage feed to PCM.
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.
Rather have a pro handle this?
A certified mobile mechanic comes to your home or office. They bring the tools, you stay comfortable. No tow truck, no waiting room, no surprises.
No obligation. See pricing before you book.