2002 Isuzu Trooper LS, RWDFACTORY OEM SERVICE PROCEDURE

Bench Testing: Rotor

  1. Check the rotor slip ring surfaces for contamination and roughness. If rough, polish with #500-600 sandpaper. See Fig 1 .
  2. Measure the slip ring diameter, and replace if it exceeds the limit.
  3. Check resistance between slip rings, and replace if there is no continuity. See Fig 2 .
  4. Check for continuity between slip ring and rotor core. In case of continuity, replace the rotor assembly.
Fig 1: Checking For Contamination Roughness & Measuring Slip Ring
G00211941Courtesy of ISUZU MOTOR CO.
Factory Service Tools

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • β€’ You smell fuel, burning insulation, or see smoke.
  • β€’ Brakes feel soft, pull hard to one side, or make grinding noises.
  • β€’ The engine overheats, stalls repeatedly, or misfires under load.
  • β€’ You are missing required tools, torque specs, or safe lifting equipment.
  • β€’ You are not confident in the next step or safety outcome.