Safety Warning

DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.

2002 Isuzu Rodeo LS, 2.2 DFACTORY OEM SERVICE PROCEDURE

Ignition Module: Installation

Install the ignition module (1).
Connect ignition module connector and ignition coil, then tighten bolt to the specified torque.
1. Torque: 10 N.m (87 lb in)
Fig 1: Installing Ignition Module
Connect ignition module connector.
Connect battery ground cable.

Chapter Navigation

Return to Chapter: Ignition Module

Factory Service Tools

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.

Shop Manual-Ready Tools Compare Repair Quote Quote Shield Pro

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

• You smell fuel, burning insulation, or see smoke.
• Brakes feel soft, pull hard to one side, or make grinding noises.
• The engine overheats, stalls repeatedly, or misfires under load.
• You are missing required tools, torque specs, or safe lifting equipment.
• You are not confident in the next step or safety outcome.