Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
2002 Isuzu Axiom Base, RWDFACTORY OEM SERVICE PROCEDURE
"Check Trans" Check
- Indicator is ON during 2- 3 seconds at ignition (or when the engine is cranked) but it is OFF after the engine starts. The indicator is working normally GO TO DIAGNOSTIC CHECK
.
Normal
Abnormal
- Indicator is flashing and the flash is 0.2 seconds ON and 0.2 seconds OFF always when ignition is on (engine cranked or not). This means that there is a malfunction. GO TO DIAGNOSTIC CHECK .
- Indicator is staying ON always when Ignition is ON.
- This means that connection between the lamp and the indicator control unit is shorted to ground.
- Verify if instrument panel terminal 27 of connector I-24 is shorted to ground.
- Verify if the indicator control unit connector B-16 terminal 20 is shorted to ground.
- Verify that the instrument panel terminal 14 of connector I-24 is connected to battery.
- If problem solved: GO TO CHECK TRANS INDICATOR
.
NO: Replace Powertrain Control Module (PCM).
- Indicator is staying OFF with the ignition ON (engine OFF).
- This means that connection between the lamp and the indicator control unit is shorted to battery or opened.
- Verify if instrument panel terminal 27 of connector I-24 is shorted to battery or open.
- Verify if the indicator control unit connector B-16 terminal 20 is shorted to battery or open.
- Verify that the instrument panel terminal 14 of connector I-24 is connected to battery. If not, check the fuses and the connections (terminal 7 of connector H-17) voltage.
- If problem solved: GO TO CHECK TRANS INDICATOR .
NO: Replace Powertrain Control Module (PCM).
Factory Service Tools
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.
