2002 Isuzu Axiom Base, RWDFACTORY OEM SERVICE PROCEDURE

Select Cable: Removal

  1. Set selector lever in "P" position.
  2. Remove knee pads, cluster upper cover, center cluster assembly, rear console, front console, selector lever knob and cover assembly.
  3. Disconnect inner cable by pulling projection on pin.
    Fig 1: Disconnecting Inner Cable By Pulling Projection On Pin
    G02808352Courtesy of ISUZU MOTOR CO.
  4. Press down claws and disconnect cable assembly.
    Fig 2: Disconnecting Cable Assembly
    G02808353Courtesy of ISUZU MOTOR CO.
  5. Remove nuts that fasten grommet in select cable assembly.
  6. Disconnect inner cable.
    Fig 3: Disconnecting Inner Cable
    G02808354Courtesy of ISUZU MOTOR CO.
  7. Slide sleeve and disconnect cable assembly.
    Fig 4: Sliding Sleeve & Disconnecting Cable Assembly
    G02808355Courtesy of ISUZU MOTOR CO.
  8. Pull lock.
    Fig 5: Pulling Lock
    G02808356Courtesy of ISUZU MOTOR CO.
  9. Draw select cable assembly into the interior side.
Factory Service Tools

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • β€’ You smell fuel, burning insulation, or see smoke.
  • β€’ Brakes feel soft, pull hard to one side, or make grinding noises.
  • β€’ The engine overheats, stalls repeatedly, or misfires under load.
  • β€’ You are missing required tools, torque specs, or safe lifting equipment.
  • β€’ You are not confident in the next step or safety outcome.