2002 Isuzu Axiom Base, RWDFACTORY OEM SERVICE PROCEDURE

Mode Switch: Removal

  1. Place selector lever in neutral.
  2. Disconnect battery ground cable.
  3. Remove mode switch cover (1) (V6).
  4. Disconnect selector lever (2) from the mode switch.
  5. Remove bracket with cable (3).
  6. Disconnect transmission harness from the mode switch connector (4).
  7. Remove bracket with mode switch connector from the transmission case.
  8. Remove mode switch connector (4) from the bracket (5).
  9. Remove two mode switch bolts and nut then remove mode switch (6).
    Fig 1: Removing Mode Switch
    G02808367Courtesy of ISUZU MOTOR CO.
Factory Service Tools

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • β€’ You smell fuel, burning insulation, or see smoke.
  • β€’ Brakes feel soft, pull hard to one side, or make grinding noises.
  • β€’ The engine overheats, stalls repeatedly, or misfires under load.
  • β€’ You are missing required tools, torque specs, or safe lifting equipment.
  • β€’ You are not confident in the next step or safety outcome.