Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
2002 Isuzu Axiom Base, RWDFACTORY OEM SERVICE PROCEDURE
Control Units
CONTROL UNITS LOCATION
| Component | Component Location |
|---|---|
| Alarm & Relay Control Unit | On right side of dash. |
| Electronic Hydraulic Control Unit (EHCU) | Right rear corner of engine compartment. See Figure . |
| Intelligent Suspension Control Unit | Below center of dash. |
| ION Sensing Module | On top of intake manifold. See Figure . |
| Keyless Entry & Anti-Theft Control Unit | On right side of dash, behind glove box. |
| Multi-Plexed Indicator Control Unit | Under rear of center console. See Figure . |
| Powertrain Control Module (PCM) | Left side of engine compartment. See Figure . |
| Sensing & Diagnostic Module (SDM) | Under front of center console. |
| Shift Lock Controller | Under center console. |
| Shift-On-The-Fly Controller | Behind the radio. |
| Sun Roof Control Unit/Motor | Center front of roof. |
| TOD Control Unit | Below left side of dash. See Figure . |
Factory Service Tools
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.