Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
2002 Isuzu Axiom Base, 4WDFACTORY OEM SERVICE PROCEDURE
Fuel Tank Leak Check
CAUTION:
Before attempting fuel tank leak check, place a dry chemical (Class B) fire extinguisher near work area. Before removing fuel tank, ensure fuel hoses and fuel sender gasket are not leaking onto tank.
- Relieve fuel system pressure. See FUEL SYSTEM PRESSURE RELEASE . Remove fuel tank. See FUEL TANK under FUEL SYSTEM in REMOVAL, OVERHAUL & INSTALLATION article. Plug filler neck, vent hoses and fuel lines.
- Install short piece of fuel line on fuel tank meter vent tube. Apply approximately 1-1.5 psi (7-10 kPa) of air pressure to tank through vent tube. Test suspect area with soap solution or by submersion. If leak is found, replace tank.
Factory Service Tools
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.
Rather have a pro handle this?
A certified mobile mechanic comes to your home or office. They bring the tools, you stay comfortable. No tow truck, no waiting room, no surprises.
Comes to youSame-day available12-month warranty
Get a Free QuoteNo obligation. See pricing before you book.