Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
2002 Isuzu Axiom Base, 4WDFACTORY OEM SERVICE PROCEDURE
Generators & Regulators: Overhaul: Generator: Disassembly
- Remove the through bolt. Insert the tip of a pry bar into the gaps between the front cover and the stator core. Pry apart and separate the front cover, rotor, the rear cover and stator. See Fig 1
.NOTE: Take care not to scratch or otherwise damage the stator coil with pry bar.
- Clamp the rotor in a vise and then remove the nut and pulley.
- Remove the rotor assembly from front cover. See Fig 2 .
- Remove the screws with bearing retainer from front cover and remove bearing. See Fig 3 .
- Remove the mounting nuts holding the "B" terminal, the diode, and the brush holder.
- Separate the rear cover from the stator. See Fig 4 .
- Remove bolts which secure stator terminal to rectifier terminal, and remove stator. See Fig 5 .
- Remove bolts which secure regulator, rectifier and brush-holder, and separate these parts. See Fig 6
.NOTE: Do not apply a shock or load to regulator, rectifier and brush holder.
Factory Service Tools
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- β’ You smell fuel, burning insulation, or see smoke.
- β’ Brakes feel soft, pull hard to one side, or make grinding noises.
- β’ The engine overheats, stalls repeatedly, or misfires under load.
- β’ You are missing required tools, torque specs, or safe lifting equipment.
- β’ You are not confident in the next step or safety outcome.
