2002 Isuzu Axiom 2WD V6-3.5LFACTORY OEM SERVICE PROCEDURE

Anti-Theft & Keyless Entry Control Unit Replacement

Anti-theft & Keyless Entry Control Unit Replacement

1. Remove and install the control unit.
- Refer to Anti-Theft & Keyless Entry Controller in this section.

2. Register ID code.
- Refer to ID Code Registration in this section.

3. Check that the keyless entry system works normally.
Factory Service Tools

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • β€’ You smell fuel, burning insulation, or see smoke.
  • β€’ Brakes feel soft, pull hard to one side, or make grinding noises.
  • β€’ The engine overheats, stalls repeatedly, or misfires under load.
  • β€’ You are missing required tools, torque specs, or safe lifting equipment.
  • β€’ You are not confident in the next step or safety outcome.