Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
2001 Isuzu Rodeo LS 4WD V6-3.2LFACTORY OEM SERVICE PROCEDURE
Shift on the Fly Controller
Removal
1. Disconnect the battery ground cable.
2. Remove the front console assembly.
3. Disconnect the connector from the controller.
4. Remove the nut.
5. Remove the controller.
Installation
1. To install, follow the removal steps in the reverse order, noting the following points.
Torque: Nut (1) 8 Nm (69 inch lbs.)
Factory Service Tools
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.