2001 Isuzu Rodeo LS 2WD V6-3.2LFACTORY OEM SERVICE PROCEDURE

Keyless Entry: Testing and Inspection

ID CODE REGISTRATION

The following procedures are available to register keyless entry ID codes.

There are four different ID codes which can be registered for each vehicle.

Steps 1 - 9:

Factory service manual diagram



ID Code New Registration
This procedure erases all registered ID codes and registers a new ID code instead.

Steps 1 - 9:

Factory service manual diagram



ID Code Additional Registration
This procedure additionally registers a new ID code with holding registered ID codes. If total number of registered ID codes and newly registered ID code exceed four, the oldest one is erased.

Steps 1 - 5:

Factory service manual diagram



ID Code Check
This procedure checks how many ID codes are registered.

Steps 1 - 5:

Factory service manual diagram



Answer Back (Anti-theft Horn Operation) Change Mode
The anti-theft horn sounds when the doors are locked or unlocked by the keyless entry transmitter operation when the answer back function is ON, and the horn does not sound when the function is OFF.



Factory Service Tools

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • β€’ You smell fuel, burning insulation, or see smoke.
  • β€’ Brakes feel soft, pull hard to one side, or make grinding noises.
  • β€’ The engine overheats, stalls repeatedly, or misfires under load.
  • β€’ You are missing required tools, torque specs, or safe lifting equipment.
  • β€’ You are not confident in the next step or safety outcome.