Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
2000 Isuzu VehiCROSSFACTORY OEM SERVICE PROCEDURE
Rotor Assembly
- Measure diameter of slip rings. If slip ring diameter is less than 1.02" (26 mm), replace rotor. See OVERHAUL . If slip ring diameter is within specification, go to next step.
- Using a DVOM, check rotor coil resistance between slip rings. If resistance is 3.75 ohms or less, go to next step. If resistance is not indicated, replace rotor. See OVERHAUL .
- Using a DVOM, check continuity between slip ring and rotor core. If continuity is indicated, replace rotor. See OVERHAUL . If continuity is not indicated, rotor is okay.
Factory Service Tools
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.