2000 Isuzu Trooper LS, RWDFACTORY OEM SERVICE PROCEDURE

Front Door Assembly: Installation

To install, follow the removal steps in the reverse order, noting the following points:

  1. Align the door fitting to the body by referring to Body Dimensions Body DimensionΒ  .
  2. Tighten the door hinge bolts to the specified torque.

    Torque:Β  34 N.m (25 lb ft)

  3. Apply chassis grease to the door check arm pin and the door hinge moving surface.
Factory Service Tools

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • β€’ You smell fuel, burning insulation, or see smoke.
  • β€’ Brakes feel soft, pull hard to one side, or make grinding noises.
  • β€’ The engine overheats, stalls repeatedly, or misfires under load.
  • β€’ You are missing required tools, torque specs, or safe lifting equipment.
  • β€’ You are not confident in the next step or safety outcome.