2000 Isuzu Trooper LS V6-3.5LFACTORY OEM SERVICE PROCEDURE

Camber

CAMBER

Factory service manual diagram



Factory service manual diagram




The camber angle can be adjusted by means of the camber shims(2) installed in position between the chassis frame (1) and fulcrum pins.
Camber angle: 0° ± 30'
King pin inclination: 12°30' ± 30'
Left and right side must be equal within 30'
Overall thickness of caster shim and camber shim should be 10.8 mm (0.425 inch) or less
Tighten the fulcrum pin bolt to the specified torque.
Torque: 152 Nm (112 ft. lbs.)
Factory Service Tools

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • β€’ You smell fuel, burning insulation, or see smoke.
  • β€’ Brakes feel soft, pull hard to one side, or make grinding noises.
  • β€’ The engine overheats, stalls repeatedly, or misfires under load.
  • β€’ You are missing required tools, torque specs, or safe lifting equipment.
  • β€’ You are not confident in the next step or safety outcome.

Rather have a pro handle this?

A certified mobile mechanic comes to your home or office. They bring the tools, you stay comfortable. No tow truck, no waiting room, no surprises.

Comes to youSame-day available12-month warranty
Get a Free Quote

No obligation. See pricing before you book.