Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
2000 Isuzu Trooper LS V6-3.5LFACTORY OEM SERVICE PROCEDURE
Cruise Control Main Switch
REMOVAL
1. Disconnect the battery ground cable.
2. Remove the front console assembly (1). Refer to Instrument Panel, Gauges and Warning Indicators.
3. Remove the lower cluster assembly (2). Refer to Instrument Panel, Gauges and Warning Indicators.
4. Remove the instrument panel driver lower cover assembly (3). Refer to Instrument Panel, Gauges and Warning Indicators.
5. Remove the instrument panel cluster assembly (5). Refer to Instrument Panel, Gauges and Warning Indicators.
6. Disconnect the and push the lock from the side of the instrument panel cluster assembly to remove the cruise control main switch (4).
INSTALLATION
To install, follow the removal steps in the reverse order, noting the following point.
1. Push in the switch with your fingers until the switch is locked securely.
Factory Service Tools
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- β’ You smell fuel, burning insulation, or see smoke.
- β’ Brakes feel soft, pull hard to one side, or make grinding noises.
- β’ The engine overheats, stalls repeatedly, or misfires under load.
- β’ You are missing required tools, torque specs, or safe lifting equipment.
- β’ You are not confident in the next step or safety outcome.
