2000 Isuzu Rodeo S, 2.2 DFACTORY OEM SERVICE PROCEDURE

Ground Circuits

  1. Disconnect PCM connectors. Using an ohmmeter, check for continuity to ground on PCM harness ground terminals. See PCM GROUND CIRCUIT TERMINALS  table. Resistance should be zero ohms. If not, locate and repair open in wire.
    PCM GROUND CIRCUIT TERMINALS

    Vehicle PCM Connector Terminal No.
    Amigo, Rodeo & Trooper (V6) Blue F1
    Blue F40
    Red S1
    Red S23
    Red S40
    Hombre C1 18
    C1 60
    C2 21
    Except Amigo, Hombre, Rodeo & Trooper (V6) White C7
    White C8
    White C9
  2. Reconnect PCM connectors. Using a voltmeter, connect negative lead of voltmeter to a good ground. Backprobe positive lead of voltmeter to each ground terminal. With vehicle running, voltmeter should indicate less than one volt. If voltmeter reading is greater than one volt, check for open, short, corrosion or loose connection on ground circuit. Repair as necessary.
Factory Service Tools

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.

Shop Manual-Ready ToolsCompare Repair QuoteQuote Shield Pro

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • • You smell fuel, burning insulation, or see smoke.
  • • Brakes feel soft, pull hard to one side, or make grinding noises.
  • • The engine overheats, stalls repeatedly, or misfires under load.
  • • You are missing required tools, torque specs, or safe lifting equipment.
  • • You are not confident in the next step or safety outcome.

Rather have a pro handle this?

A certified mobile mechanic comes to your home or office. They bring the tools, you stay comfortable. No tow truck, no waiting room, no surprises.

Comes to youSame-day available12-month warranty
Get a Free Quote

No obligation. See pricing before you book.