Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
Circuit Description
Engine load is determined using a "speed density" method. This method is calculated using inputs from Manifold Absolute Pressure (MAP) sensor, Crankshaft Position (CKP) sensor, Intake Air Temperature (IAT) sensor and engine RPM. The MAP sensor is the main sensor used to calculate engine load. Powertrain Control Module (PCM) supplies a 5-volt reference signal and a ground circuit to MAP sensor. As manifold pressure changes, MAP sensor input voltage to PCM varies from less than 2 volts at idle to greater than 4 volts at Wide Open Throttle (WOT). If PCM detects MAP sensor input voltage that is excessively low, DTC P0106 will be set.
Conditions required to set DTC are:
- No ECT, CKP, EGR, EVAP, MAP or TP sensor DTCs present.
- ECT is greater than 14Β°F (-10Β°C).
- EGR flow rate is steady, changing less than 2 percent.
- Engine speed is steady 1000-4000 RPM, and changing less than 20 RPM.
- IAC valve counts are steady, changing less than 3 counts.
- TP sensor position does not vary more than 5 percent.
- No status change in brake switch, A/C clutch or power steering pressure switch.
- MAP value varies more than 10 kPa, for a total of 10 seconds within a 20-second time sample.
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- β’ You smell fuel, burning insulation, or see smoke.
- β’ Brakes feel soft, pull hard to one side, or make grinding noises.
- β’ The engine overheats, stalls repeatedly, or misfires under load.
- β’ You are missing required tools, torque specs, or safe lifting equipment.
- β’ You are not confident in the next step or safety outcome.
