Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
2000 Isuzu Rodeo LS, 2.2 DFACTORY OEM SERVICE PROCEDURE
Control Units
CONTROL UNITS
| Component | Component Location |
|---|---|
| Alarm & Relay Control Unit | Above right kick panel. |
| Cruise Control Unit | Under rear of center console. |
| Electronic Brake Control Module (EBCM) | On right rear corner of engine compartment. |
| Engine Control Module (ECM) (2.2L M/T) | Below center of dash. See Figure. |
| Engine Control Module (ECM) (3.2L M/T) | Left rear corner of engine compartment, mounted on inner fender. See Figure |
| Ignition Control Module (ICM) (2.2L) | On right rear of engine. |
| Keyless Entry & Security Control Unit | Above right kick panel. |
| Moon Roof Control Unit | Center front of roof. |
| Powertrain Control Module (PCM) (3.2L) | Left rear corner of engine compartment, mounted on inner fender. See Figure |
| Sensing & Diagnostic Module (SDM) | Below center of dash. See Figure. |
| Shift-On-The-Fly Controller | Right side of driver's footwell, behind center console, left of radio. |
| 4WD Control Unit | Under center console. |
Factory Service Tools
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.