Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
2000 Isuzu Rodeo LS, 2.2 DFACTORY OEM SERVICE PROCEDURE
Stator Coil
- Using an ohmmeter, check continuity across stator coil leads. If continuity does not exist, replace stator coils. See OVERHAUL .
- Measure resistance across stator coil, reading should be about .07 ohms at 68°F (20°C). If reading is not as specified, replace stator. See OVERHAUL .
- Connect ohmmeter between stator core and each stator coil lead. If continuity exists, replace stator coil. See OVERHAUL .
Factory Service Tools
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.