Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
2000 Isuzu Rodeo LS, 2.2 DFACTORY OEM SERVICE PROCEDURE
Torque Specifications
TORQUE SPECIFICATIONS
| Application | Ft. Lbs. (N.m) | |||
|---|---|---|---|---|
| Brakeline-To-Hydraulic Unit | 12 (16) | |||
| Hydraulic Unit Ground Cable Bolt | 10 (14) | |||
| Hydraulic Unit Mounting Nut | 16 (22) | |||
| Front Wheel Speed Sensor Cable Bolt | ||||
| Lower | 18 (24) | |||
| Upper | (1) | |||
| Wheel Lug Nut | 87 (118) | |||
| INCH Lbs. (N.m) | ||||
| Front Wheel Speed Sensor Mounting Bolt | 95 (11.0) | |||
| Rear Wheel Speed Sensor Mounting Bolt | 95 (11.0) | |||
|
||||
Factory Service Tools
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.