Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
2000 Isuzu Amigo 2WD L4-2.2LFACTORY OEM SERVICE PROCEDURE
Alignment
| Trim Height | 119 οΏ½ 5 mm (4.69 οΏ½0.2 in) |
| Caster Angle | 2°30' οΏ½ 45' Left and right side must be equal within 30'. |
| Camber Angle | 0° οΏ½ 30' Left and right side must be equal within 30'. |
| King Pin Inclination | 12°30' οΏ½ 30' |
| Toe-In | 0 οΏ½ 2 mm (0 οΏ½ 0.08 in) |
Factory Service Tools
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- β’ You smell fuel, burning insulation, or see smoke.
- β’ Brakes feel soft, pull hard to one side, or make grinding noises.
- β’ The engine overheats, stalls repeatedly, or misfires under load.
- β’ You are missing required tools, torque specs, or safe lifting equipment.
- β’ You are not confident in the next step or safety outcome.