1999 Isuzu Trooper Part TimeFACTORY OEM SERVICE PROCEDURE

Wheel Alignment Specifications

WHEEL ALIGNMENT SPECIFICATIONS (AMIGO, RODEO & RODEO SPORT)

Application Preferred Range
Camber (1) 0 -.5-.5
Caster (1) 2.5 1.5-3.5
Amigo & Rodeo 2.5 1.5-3.5
Rodeo Sport 2.5 1.75-3.25
Toe-In (2) 0 -0.08-0.08 (-2.00-2.00)
KPI (1) 12.5 12-13
(1) Measurement in degrees.
(2) Measurement in inches (mm).
WHEEL ALIGNMENT SPECIFICATIONS (HOMBRE)

Application Preferred Range
Camber (1) 0 -1-1
Caster (1)(2) 3 2-4
Toe-In (3) 0.10 (2.54) -0.10-0.10 (-2.54-2.54)
(1) Measurement in degrees.
(2) Adjust caster to 1-3 degrees (2 degrees preferred) on models with RPO codes G51, ZM6, ZR2 and Z85.
(3) Measurement in inches (mm).
WHEEL ALIGNMENT SPECIFICATIONS (TROOPER)

Application Preferred Range
Camber (1) 0 -.5-.5
Caster (1) 2.17 1.42-2.92
Toe-In (2) 0 -0.08-0.08 (-2.00-2.00)
(1) Measurement in degrees.
(2) Measurement in inches (mm).
WHEEL ALIGNMENT SPECIFICATIONS (VEHICROSS)

Application Preferred Range
Camber (1) 0 -.5-.5
Caster (1) 2.08 1.33-2.83
Toe-In (2) 0 -0.08-0.08 (-2.00-2.00)
(1) Measurement in degrees.
(2) Measurement in inches (mm).
Factory Service Tools

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.

Shop Manual-Ready ToolsCompare Repair QuoteQuote Shield Pro

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • • You smell fuel, burning insulation, or see smoke.
  • • Brakes feel soft, pull hard to one side, or make grinding noises.
  • • The engine overheats, stalls repeatedly, or misfires under load.
  • • You are missing required tools, torque specs, or safe lifting equipment.
  • • You are not confident in the next step or safety outcome.