Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
Electronic Hydraulic Control Unit: Notes
Electronic Hydraulic Control Unit (EHCU) includes ABS control circuits, fault detector and a fail safe system. EHCU controls hydraulic unit according to signals received from "G" sensor/accelerometer, brakelight switch and each wheel speed sensor. EHCU determines if a wheel is beginning to lock. If a locking condition is detected, EHCU sends a signal to hydraulic unit, adjusting brake pressure to provide for maximum braking without wheel lock.
EHCU is mounted on right front side of engine compartment and consist of motor, plunger pump, solenoid valves and check valve. A relay box containing motor relay and valve relay is mounted on outside of EHCU. EHCU component functions are as follows:
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- β’ You smell fuel, burning insulation, or see smoke.
- β’ Brakes feel soft, pull hard to one side, or make grinding noises.
- β’ The engine overheats, stalls repeatedly, or misfires under load.
- β’ You are missing required tools, torque specs, or safe lifting equipment.
- β’ You are not confident in the next step or safety outcome.
