Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
1999 Isuzu Rodeo LS 2WD V6-3.2LFACTORY OEM SERVICE PROCEDURE
Alignment Shims
SERVICE SPECIFICATIONS
Difference of the caster shim front/rear thickness should be 3.6 mm (0.142 in.) or less.
Overall thickness of caster shim and camber shim should be 10.8 mm (0.425 in.) or less.
TORQUE SPECIFICATIONS
Fulcrum Pin Attaching Bolt 152 Nm (112 ft. lbs.)
Difference of the caster shim front/rear thickness should be 3.6 mm (0.142 in.) or less.
Overall thickness of caster shim and camber shim should be 10.8 mm (0.425 in.) or less.
TORQUE SPECIFICATIONS
Fulcrum Pin Attaching Bolt 152 Nm (112 ft. lbs.)
Factory Service Tools
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.