Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
1999 Isuzu Rodeo LS 2WD V6-3.2LFACTORY OEM SERVICE PROCEDURE
Power Door Lock Control Module: Service and Repair
Disassembly and assembly of the transmitter include details of spare parts and replacement procedure for defective parts found through troubleshooting. Each part is a precise electronic components to handle with care.
Spare Parts And Replacement Procedure For Malfunctioning Parts:
For malfunctioning transmitter:
1. Prepare a new transmitter (1).
2. Programs VAC (Vehicle Access Code) (2).
3. Check that the door lock remote control operation works (3). (4).
For malfunctioning battery:
1. Prepare new batteries (1) (Type : CR2016x2).
2. Remove the batteries from transmitter (2).
3. Install a new batteries into transmitter.
4. Check that the door lock remote control operation works.
For malfunctioning ECU:
1. Prepare a new ECU (1).
2. Remove the battery from transmitter (2).
3. Install a new ECU in the vehicle.
4. VAC (Vehicle Access Code) programs (3).
5. Check that the door lock remote control operation works.
Replace Battery For Transmitter
1. Remove the batteries.
2. Set new batteries into the transmitter.
3. Install the cover to the transmitter.
Spare Parts And Replacement Procedure For Malfunctioning Parts:
For malfunctioning transmitter:
1. Prepare a new transmitter (1).
2. Programs VAC (Vehicle Access Code) (2).
3. Check that the door lock remote control operation works (3). (4).
For malfunctioning battery:
1. Prepare new batteries (1) (Type : CR2016x2).
2. Remove the batteries from transmitter (2).
3. Install a new batteries into transmitter.
4. Check that the door lock remote control operation works.
For malfunctioning ECU:
1. Prepare a new ECU (1).
2. Remove the battery from transmitter (2).
3. Install a new ECU in the vehicle.
4. VAC (Vehicle Access Code) programs (3).
5. Check that the door lock remote control operation works.
Replace Battery For Transmitter
1. Remove the batteries.
2. Set new batteries into the transmitter.
3. Install the cover to the transmitter.
Factory Service Tools
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.